Dr. Blip's PC-Doctor Forum

General Category => Ask Our Experts => Topic started by: chrmarker on August 20, 2008, 10:19:11 pm

Title: Error detected in batch-mode
Post by: chrmarker on August 20, 2008, 10:19:11 pm

Hi PC-DOC experts

In the end of a Normal test with boot floppy diskette I get this message:

"Error detected in batch-mode diagnostic testing."

what does this meean?

In the FAQ it says that I should look in the log file, but where can i find that?

 All I can do after the test is done and I get the "Error detected in batch-mode diagnostic testing" message is to hit enter and start the test over again.

Hope someone can help.  :)

Title: Re: Error detected in batch-mode
Post by: fwilson on August 21, 2008, 07:52:03 am

Chrmarker,

Pressing F3 at the completion of the tests will bring up the log window.  You can then view, print or save the logs from there.

-Fred